Epoxy All Thread Into Concrete

Epoxy adhesive et hp is a two part epoxy formulated for anchoring threaded rod and rebar in cracked and uncracked concrete applications.

Epoxy all thread into concrete.

Code listed per icc es esr 3372 concrete and iapmo ues er 241 masonry. Since the epoxy is stronger than the concrete the ultimate anchor load will be limited only by the concrete or capacity of the steel. Anchoring handrails or securing any object to concrete or masonry using threaded rods rebar bolts or dowels requires a high strength permanent bond especially applications that will be subjected to heavy loads or vibration. Depending upon your specific anchoring application quikrete manufactures an anchoring epoxy that will fit your project requirements.

Epoxy can be used for anchoring handrails or securing objects to concrete or masonry using threaded rods rebar bolts or dowels that require a high strength and permanent bond. The epoxy distributes the transmitted load from the dowel into the concrete over the entire surface of the anchor hole. This is a very common use of all thread rod. When anchor bolts are needed in pre existing concrete a hole is drilled into the concrete then the hole is filled with epoxy and a piece of all thread rod is placed in the hole.

Bars can be ordered cut to length or in stock lengths up to 50 feet for job site cutting. Anchoring bolts railings and rebar in concrete with anchoring epoxy. Sometimes installation of threaded rod or rebar needs to be conducted in cold temperatures some even lower than 41 f. Once the epoxy bonds with the threads on the all thread rod it provides pullout resistance allowing the rod to act as an anchor bolt.